Below are the available bulk discount rates for each individual item when you purchase a certain amount
● YUMINASHI TYPE-3D DENSO (30/34MM) MANIFOLD (FOR DENSO INJECTOR TYPE) (MSX/MONKEY/CRF110F/...)
● If you are talking "big bore", then this is the manifold you are looking for...
Choosing the “right” intake manifold for an engine is just as important as choosing the right camshaft, cylinder head and compression ratio.
All of these components have to complement one another and work in harmony together otherwise the engine will never realize its true power potential.
● The Yuminashi Type-3D manifold is plug & play ready to be installed on a 30mm (1.18110236 inches) intake port in combination with a CRF250F 37mm or CBR250R 39mm throttle body.
This means that the Yuminashi Type-3D DENSO manifold has specifically been created with large 2-valve cylinder heads in mind.
● The inner diameter of the YUMINASHI TYPE-3 manifold at the intake port side is 30mm (1.18110236 inches) and is based on the specifications of the Yuminashi EVO149R Head with a 30mm intake port.
● The Type-3 manifold at throttle body side is 34mm (1.33858268 inches) and can perfectly be machined until 37mm (1.45669291 inches) to install a 37mm CRF250F throttle body, or 39mm (1.53543307 inches) to install the 39mm CBR250R throttle body which is the absolute limit for this manifold.
● The injector joint which comes with the set has been designed in such a way to allow you to make a choice to install it on the throttle body or on the manifold.
A black pin comes with the set to make it easy to block one of the two injector holes and to install the injector joint based on your preference.
● The insulator/rubber of the Type-3D manifold is plug & play ready to accept/install the CRF250F and CBR250R throttle body.
※ Keep in mind that this Type-3D manifold is mentioned to be installed with the high flow 12-holes Denso injectors, which are the standard injectors used on CRF250F, CBR250R, CBR300R and CBR600RR throttle bodies.
- Different flow rate Denso injectors can be found with this LINK.
※ The B-Type to Denso injector wire loom will be necessary to be installed on your stock wire harness LINK.
Most bikes produced from 2013 and onward have a B-type injector installed as standard, but please do check if you have actually a A-type or B-type injector as standard installed before you order the B-type to Denso wire loom...
● THE YUMINASHI TYPE-3 DENSO (30/34MM) MANIFOLD IS MENTIONED TO BE INSTALLED ON:
SMART SHOPPER TIP:
※ BUYING MORE THEN 1 PIECE CUT THE TRANSPORT PRICE, AND YOU RECEIVE A 10% DISCOUNT ON TOP OF IT!
All prices are in THB